Easy Mop Assembly

Step 1

Simply screw the three handle sections together, taking care to slip the rotating ferrule over the top section. The ferrule (which allows for the mop handle to rotate freely) has one end wider than the other. Position it on the handle so that the slightly wider end is facing down.

The three sections are made of aluminium alloy, so are strong and at the same time very light.

Between uses the handle can be broken down into its three parts for easy storage.

Step 2

This is what the EasyMop should look like when assembled. Please note that the EasyMop will free stand, wet or dry.

Handy for when the phone rings. Just leave it stand in the middle of the floor whilst you go off to speak with the nice telemarketing person. It will still be standing there when you come back!

Step 3

Finally push fit the mop head to the handle, fill the bucket with water and the unit is ready to clean. Soak the mop in the bucket of water, (take care not to overfill the bucket) and then spin out as little or as much water as you need for the job.

When the mop is dirty, simply rinse it in the bucket of water, spin it and continue cleaning.